It’s time to start working when you’ve decided on a golf grip. It is a basic and quick process to regripping golf clubs. Once you’ve mastered the technique, you can regrip golf clubs in a couple of moments. You might delegate the duty to your golfing pro. Pick a good PGA golf professional to have and put in new golf grips, and you’ll benefit from their extensive knowledge. A pro can walk you through the various grip options. A PGA professional can also assist you with typical inquiries. Should you use the same sort of grip to substitute a worn-out one? Is it time to consider a golf grip that is more suited to your game?

1. Discard the previous grip

Clamp the shaft towards the grip’s lower end. Point the club’s face toward the floor. Open the old grip. Don’t cut towards your body for your protection. Avoiding severing a graphite shaft. Remove the old grip by peeling it off and scraping the tape away. Using grip solvents and a clean cloth, remove any leftover residues.

2. Use grip tape.

Measure the new grip to see how much the shaft needs to be taped. Apply 34″ grip tape in a spiral from the top of the shaft to the grip’s end. Add 2″ longitudinal grip tape. Take off the paper covering. Wrap the shaft’s end with a little more tape.

3. Use a solvent.

Plug the gaps at the bottom of the grip with a golf tee. Pour the solvent into the grip’s open-end—spin to disperse the solvent by covering the open end with your palm. Disconnect the tee and spray the surplus solvent onto the shaft’s grip tape. Place a tray beneath the clamping shaft to capture any surplus solvent. Use the surplus solution on the other clubs if you are regripping more than one club.

4. Slide grip into position

The grip tape is still wet, position the grip and pull it down over the shaft’s butt end. Assemble the shaft so that the extremity of the shaft sits into the very bottom of the grip. Adjust the alignment so that the clubface and grip are square. You’ll have about one minute before the tape becomes too slick. Allow several hours for the additional grip to dry.

5. Go outside and have fun.

This is the exciting part. Take your regripped clubs to the first tee and begin playing!

Methods other than

Traditional grip solvents are not required. There are also solvent options that are less harmful to the environment, such as water and soap, and pressurized air. The main distinction is in long waits. The solvent-based technique necessitates around two hours of drying time. The water-based method requires a drying time of roughly 24 hours. The use of compressed air removes the need for drying time entirely.

If you have access to compressed air, purchase a specially designed compression tip from a golf supply store. Connect it to the pressurized air supply and put the other end into the hole on the grip’s butt-end. The pressurized air will cause the new grip to stretch, enabling it to be slipped and overgrip tape. As you take out the pressure point, the grip shrinks back to its original size, firmly clinging to the grip tape. It is also feasible to use pressurized gas to eliminate outdated grips.

How to Select Golf Grips for Regripping a Golf Club

To get the best golf grips, a player must consider several factors.

Size

You can choose from large, medium, regular, or undersize grips, depending on your hand size. Build-up tape provides for more exact size fitting. When gripping the club, your fingertips should be gently touching the base of your thumb. If they dig too deeply into your hand, your grasp is too tiny; if your fingers do not touch, your grips are too wide. If you use the wrong grip size, your game will deteriorate.

Texture

Grip selection frequently entails striking a balance between feel and club security. During the swing, any deflection of the grip in the hands bodes danger. Trying to strangle the club with extreme grip pressure, on the other hand, is unhelpful. Remember that the requirements of a hard-swinging youngster may vary markedly from those of a senior with a more leisurely swing.

Firmness

The greater the swing velocity, the more torsion control is required. Also, when coupled with the lesser grip pressure desired by better players, a hard grip enables stability. At higher swing speeds, a soft hold may produce extra torque. Others with lower swing speeds and less hand strength, on the other hand, may choose softer, tackier grips. Tensile management is less of a challenge for them. You may employ an overly hard grip without even recognizing it with the incorrect grip. You’re making up for lack of strength with a grip that’s too light for your swing.

Golfers who frequently play in rainy or humid conditions may like the powdery surface of a corded grip. If you’ve ever seen a club fly out of a player’s hands at impact, you understand the value of a sticky and textured grip. Any motion during the swinging has the potential to destroy the shot. Some players think that the material of a corded grip is too rough on their hands, especially if they grip the club tightly. In the rainfall, some plastics and polymer grips become slick. Flawless gripping may necessitate the use of tack sprays on occasions.